Table of Contents
Advertisement
The following instructions describe the installation process for a point-
to-point installation. The procedure is similar for compatible HDBaseT
components. In the event the DIGI-BSR-4K cannot provide power over
the HDBaseT cable connection, the HDBaseT transmitter will require a
local power supply.
1. Verify all components included with the DIGI-BSR-4K are present
before installation.
2. If the DIGI-BSR-4K will be permanently mounted to a surface,
attach the included mounting brackets with the supplied screws.
3. Turn off power and disconnect the audio/video equipment by
following the manufacturer's instructions.
4. Connect shielded, solid core Category 5e or greater twisted pair
cable with RJ45 connectors between the HDBaseT transmitter and
the DIGI-BSR-4K. TIA/EIA-568B straight-through wiring connections
must be used with all HDBaseT extenders.
5. Connect an HDMI cable and any desired control accessories between
the source and the transmitter.
6. Connect an HDMI cable and any desired control accessories between
the display and the receiver.
7. Connect
or
Ethernet
an
Ethernet
DIGI-BSR-4K can provide up to 15 watts of power to any PoE
network device on the
8. Connect the audio output of the DIGI-BSR-4K to an audio amplifier.
9. Connect the power supply to the receiver and lock the power supply
to the power connector by twisting the locking collar clockwise.
10. Power on attached audio/video devices.
Installation Instructions
a
Category
ports
LAN (PoE)
connection
LAN (PoE)
5e
patch
and
any
from
the
port.
cable
between
device
that
transmitter.
the
requires
The
Advertisement
Table of Contents
