Step 8. Connect Lift Hose - MacDon R80 Manual
Pull-type rotary disc mower conditioner
Hide thumbs
Also See for R80:
- Operator's manual (104 pages) ,
- Unloading and assembly instructions (51 pages) ,
- Operator's manual (124 pages)
Table of Contents
Advertisement
STEP 8.
CONNECT LIFT HOSE
IMPORTANT
Hoses should be routed so there are no
twists or sharp bends and no locations
where contact with the frame is likely.
Ensure that there is sufficient length of
hose
and
accommodate full swing of hitch in both
directions.
Relocate plastic ties if
necessary to provide suitable slack in
hoses and wiring.
IMPORTANT
To
prevent
hydraulic system, extreme care must be
taken to avoid dirt entering at connection
points.
To
minimize
contamination, remove cap from one
hose and its mating connection and
connect before removing other caps and
plugs.
A
a. Connect the lift cylinder hose (A) to the fitting
on the hitch.
b. Connect electrical wiring harness (B) at rear of
hitch as shown.
Form # 169080
UNLOADING AND ASSEMBLY
wiring
in
span
to
contamination
of
the
exposure
to
B
16
Issue – April 2007
Advertisement
Table of Contents
