Step 2. Unload Header - MacDon R80 Manual

STEP 2. UNLOAD HEADER
CAUTION
To avoid injury to bystanders from being
struck by machinery, do not allow persons
to stand in unloading area.
CAUTION
Equipment used for unloading must meet
or exceed the requirements specified
below. Using inadequate equipment may
result in chain breakage, vehicle tipping or
machine damage.
LIFTING VEHICLE
MIN. LIFTING
CAPACITY
MIN. LIFTING HEIGHT
TYPE
MIN. WORKING LOAD
WARNING
Be sure forks are secure before moving
away from load. Stand clear when lifting.
Form # 169080
UNLOADING AND ASSEMBLY
8000 LB. (3630 KG)
15 FT. (4.5 M)
CHAIN
OVERHEAD LIFTING
QUALITY (1/2 INCH)
5000 LB. (2270 KG)
a. Remove hauler's tie down straps and chains.
FORKS
b. Approach windrower from either its "underside"
or "topside" and slide forks in underneath lifting
framework as far as possible.
When possible, approach from the
underside to minimize potential for
scratching the unit.
c. Raise windrower off deck.
Take care not to contact the other
machine if load is two-wide.
d. Back up until unit clears trailer and slowly
lower to 6 inches (150 mm) from ground.
e. Take to storage or set-up area set machine
down securely on level ground.
f. Repeat for other header if required.
g. Check for shipping damage and missing parts.
8
NOTE
IMPORTANT
Issue – April 2007