Coway APM-1010DH Instructions Manual page 19

Cleaning the water tank (daily)
4
Dry the water tank completely in a shady location to remove all
moisture before installing it.
-
To operate in humidifying air purification mode: Remove any
moisture from outside the water tank, fill up the water tank
with water and install the water tank.
-
To operate in air purification mode: Remove any moisture
from outside and inside the water tank and install the water
tank.
Cleaning the water tray (daily)
1
Separate the water tank from the product and separate the water tray from the side of the product by
pulling it.
-
When you remove the water
tray as shown by the figure,
take care because there may
be residual water in the hole of
the catch.
2 Carefully separate the humidification filter from the water tray.
-
When you separate the humidification filter, some water
absorbed by the filter can be extracted. Please take care of the
water.
Soak the humidification filter in warm water (40
least 20 minutes and softly wash it with a cleaning brush under
flowing water.
-
The period and intensity of the scale accumulation at the front of
the humidification filter may differ depending on the TDS of the
water. If the filter is whitened by the accumulated scale, wash it
under flowing water.
℃
or lower) for at
17
18