Table of Contents
Advertisement
z
Ivory White 1071
Bamboo 1127
Tangerine 1372
Orange 1278
Siennna 1158
x
q
e
z x c
z
Ivory White 1071
Bamboo 1127
Tangerine 1372
Orange 1278
Siennna 1158
q
Trace outline
Colors
r
View A
View A
w
Colors
Ivory White 1071
Bamboo 1127
Tangerine 1372
Orange 1278
Siennna 1158
q
Colors
w
Adjusting the start position
z Select the pattern and the hoop will move to the home
position.
x To check the needle drop position, lower the needle
bar with the small screwdriver so you can see the
needle point closer to the fabric.
Place the screwdriver on the needle clamp and push
down the needle bar until the needle bar supporter is
locked between the hooks.
q Needle clamp
w Hook
e Needle bar supporter
* The needle bar can be lowered by turning the
handwheel clockwise.
c Adjust the hoop position by pressing the jog buttons if
necessary.
r Jog buttons
The hoop will move 1mm each time you press the jog
button.
Press and hold the button and the hoop will continue
moving within the embroidery area until you release
the button.
v With the needle and foot lowered, press START/STOP
button to start stitching.
Adjusting the re-start position after thread
breakage
z Place the screwdriver on the needle clamp and push
down the needle bar until the needle bar supporter is
locked between the hooks.
(See "Adjusting the start position" above.)
x With the needle and foot lowered, press START/STOP
button to re-start stitching.
c Press the stitch back button to move the hoop a few
stitches backward.
q Stitch back button
Tracing the embroidery area
z Press the trace button to check the size and position
of the selected pattern against the hoop.
q Trace button
NOTE:
Check if the fabric edge will not obstruct the movement
of the hoop.
* Press the trace button during tracing the
embroidery area to pause tracing.
* Press the trace button again to re-start tracing.
* Press the Exit key during tracing the embroidery
area to stop tracing.
w Exit key
60
Hide quick links:
Advertisement
Table of Contents
