Installing The Rcs Unit (Optional For Some Models) - ELNA eXpressive 970 Instruction Manual

z x c
r
w
e
t
v
u
b
o
n m
r
q
y
i
View from the bottom
!0
!1
!2
!3
!4

Installing the RCS Unit (optional for some models)

z Loosen the thumbscrew and open the mounting arm.
q Thumbscrew
w Mounting arm
x Loosen the screw knob A and set the RCS unit on the
mounting arm by hooking the RCS unit on the pins.
Tighten the screw knob A to secure the RCS unit.
e Screw knob A
r RCS unit
t Pin
c Adjust the angle of the mounting arm as desired and
tighten the thumbscrew.
q Thumbscrew
w Mounting arm
v Insert the connector into the connector socket on the
back of the machine with the marks aligned.
y Connector socket
u Connector
i Mark
b Fold and secure the cable under the spool stand as
shown.
o Spool stand
!0 Cable slotted into ribs
!1 Cable coming from connector
!2 Excess cable secured in the opening
CAUTION:
Make sure to secure the cable under the spool stand.
A loose cable may interfere with the hoop.
n Loosen the screw knob B on the end of the mounting
arm and tilt the RCS unit to adjust the angle of the
LCD screen for easier viewing.
m Tighten the screw knob B to secure the RCS unit.
r RCS unit
!3 Screw knob B
If you want to use the RCS unit without installing, extend
the two legs on the backside of the RCS unit so that it
rests on an angle for easier viewing.
!4 Leg
12