ELNA eXpressive 970 Instruction Manual page 80

Jump Thread Trimming
Number of Jumps
Mnimum jump thread length to cut
Jump Thread Trimming
Number of Jumps
Mnimum jump thread length to cut
Jump Thread Trimming
Number of Jumps
Mnimum jump thread length to cut
e
24. Jump thread trimming ON/OFF
q
If you wish to trim jump threads automatically, press the
function key next to "ON".
A check mark will appear in the box.
Press the function key next to "OFF" to disable the jump
thread trimming.
q Function keys (ON, OFF)
Press the OK key.
w OK key
w
25. Jump thread trimming threshold
q
If you insert jump codes when creating a custom design
embroidery pattern using a digitizing software, you can
adjust the position of jump thread trimming by setting the
number of jump codes.
The machine will trim the jump thread automatically after
the specified number of jump codes.
Press the function key next to "+" or "–" to adjust the
number of jumps.
q Function keys (+, –)
Press the OK key.
w
w OK key
The default setting is 3 and adjustable range is from 1 to 8.
NOTE:
Turn off the setting 26 below, when using this function.
26. Jump thread trimming threshold (length)
If you do not have a digitizing software, you can adjust
q
jump thread trimming by length.
Press the function key next to "+" or "–" to set the
minimum length of jump thread to cut .
The machine will automatically cut jump threads longer
than the length selected.
q Function keys (+, –)
Press the OK key.
w OK key
w
To turn this function off, press the function key next to "+"
until "OFF" is indicated.
The adjustable range is from 1 mm to 30 mm.
NOTE:
Set the jump code number to 8 when using this
function.
76