ELNA eXpressive 970 Instruction Manual page 23

c
t
r
u
r
v
b n m , .
!3
!4
⁄0 ⁄1 ⁄2
t
u
y
u
i
!2 !0
o
!1
!6
!5
!7
!8
c Draw the thread to the right pre-tension control.
Pass the thread through the guide hole from behind.
While holding the thread with both hands, slip the
thread under the tension disk of the pre-tension
control.
Hook the thread around the guide pin from right to left
as shown in the threading path.
Make sure to insert the thread under the tension disk
by tugging the thread.
r Pre-tension control
t Guide hole
y Threading path
u Guide pin
v Hold the thread with both hands and pull it down along
the right channel.
i Tension control
b Draw the thread down and pass it through the right
hole in the guide plate.
o Guide plate
!0 Right hole in the guide plate
n Pass the thread through the eye of the right check
spring.
!1 Eye of the check spring
m Pull the thread up and pass it through the second hole
from the right.
!2 Second hole from the right
, Continue to pull the thread up to the right take-up
lever. Pass the thread through the eye of the take-up
lever.
!3 Take-up lever
. Draw the thread down and pass it through the third
hole from the right in the guide plate.
!4 Third hole from the right
⁄0 Continue to draw the thread down to the lower guide
plate and pass the thread through the right hole.
!5 Lower guide plate
!6 Right hole in the lower guide plate
⁄1 Hold the thread with both hand and slip the thread
behind in the right needle bar thread guide.
!7 Needle bar thread guide
⁄2 Thread the needle with the handy needle threader
(refer to the next page).
!8 Needle
19