Honeywell KLN 900s Pilot's Manual page 21

NOTE: In steps 6, 7, and 8, repeated presses of F will
terminate the update process and bring the display back
to the original SET 0 page shown in figure 2-2.
9. Press E to acknowledge the estimated load time
and begin erasing the existing database. The unit will
now display ERASING DATA BASE (figure 2-6). After
the database has been erased, loading of the new data
begins automatically. As the new data is being loaded,
the percentage of transfer is displayed (figure 2-7).
10. Monitor the computer screen. When updating from
disks, the computer screen will display "Insert Disk 2 then
press any key to continue" when the first disk has been
loaded. Disk 1 should now be removed from the disk
drive and disk 2 should be inserted. Press any key on the
computer. The load operation will continue. If there are 3
disks the computer screen will tell you when to insert
disk 3.
11. The KLN 900 will indicate when the database update
is complete as shown in figure 2-8. The computer screen
will display the new database expiration date. You may
either turn the KLN 900 off at this point or press E to
restart the KLN 900.
12. Remove the interface cable. Turn off the computer.
The chances are small of having difficulty updating the
database but if you have a problem:
First check that the interface cable is properly connected
and that the computer is turned on. Ensure that the inter-
face cable is firmly inserted into the jack on the front of
the KLN900. If there is a problem with the connection or
the computer the KLN 900 will display LOADER NOT
READY. When the problem is corrected this prompt is
removed and the update operation can continue from
where it left off.
If the wrong disk is inserted the computer screen will dis-
play "Incorrect Disk - please insert disk __" where the
number 2 or 3 is inserted in the blank.
If an internal test fails after the data has been loaded, the
KLN 900 will display CHECKSUM ERROR, DATA BASE
INVALID, ACKNOWLEDGE?.
edge. The KLN 900 will then display RETRY and EXIT.
Use the left outer knob to position the cursor over the
desired choice and press E.
There are other error messages that may be displayed. If
you have a problem that you can't resolve, write down
any error messages to aid your Bendix/King Service
Center in identifying the problem.
Press E to acknowl-
D A T A
D A T A
SET 0
D A T A
14 PERCENT COMPLETE
SET 0
D A T A
UPDATE PUBLISHED DB
CRSR
2-6
U P D A T E
B A S E
E R A S I N G
B A S E
Figure 2-6
U P D A T E
B A S E
Figure 2-7
U P D A T E
B A S E
COMPLETED
ACKNOWLEDGE?
ent
Figure 2-8
Rev 2