Encoder; Selecting A Port Or Channel Option; Enabling Video Input Termination; Setting Up Ptz - Avigilon H3-B1 User Manual

Encoder

Avigilon H.264 encoders use many of the same settings as the cameras,
but the following settings are only available to encoders.

Selecting a Port or Channel Option

An encoder can have up to 4 cameras and 4 audio devices connected at
one time, so some pages in the web interface include a set of options for
each port or channel on the encoder.
On pages with live video options, like Live View and Motion Detection, you
can change the displayed camera by selecting a Port number from the
drop down list.
On setup pages without video, the options are divided by video port or
audio channel so that different options can be applied to each.

Enabling Video Input Termination

• To enable the video input termination, select a Port check
box on the General page.

Setting Up PTZ

The H.264 encoders have pan, tilt and zoom (PTZ) setup options. Once
enabled, the Live View will display the PTZ controls for the camera.
1. Among the Setup options, click PTZ.
2. Select a Baud Rate and Parity.
3. For each port that is connected to a PTZ camera, select the
Enable PTZ check box.
4. Select a Protocol and enter a Dip Switch Address.
5. Click Apply.
6. To use the PTZ controls, see Using the Encoder PTZ Controls on
page 6.
25