Setup; General - Avigilon H3-B1 User Manual

Setup

NOTE: Some or all Setup pages may not be displayed if you do not have
the required user permissions.
The device's factory default settings allow you to use the camera or
encoder immediately after installation. If you have special requirements,
you can customize the settings through the web interface.
A Restore Default button is available on each Setup page to allow you to
restore the factory default settings.
Be aware that some of the settings are only available through the camera
web interface and can not be changed in the network video management
software.
The following Setup pages in the web interface are common across all
Avigilon H.264 devices unless otherwise noted.
For the settings that are specific to PTZ cameras, see PTZ Camera on
page 21.
For the settings that are specific to encoders, see Encoder on page 25.

General

When you select the Setup link, the first page you see is the General
page. The General page allows you to set the device identity.
1. In the Name field, give the device a meaningful name.
2. In the Location field, describe the device's location.
3. Select the Disable camera status LEDs check box to disable the
LEDs located on the device.
4. Click Apply.
7