Network - Avigilon H3-B1 User Manual

Network

On the Network page, you can change how the device connects to the
server network and choose how the device keeps time.
NOTE: You can only set the HTTPS port, the RTSP port, and the NTP
Server in the camera web interface.
1. In the Address and Hostname area, select how the device obtains
an IP address:
• Obtain an IP address automatically: select this option to
connect to the network through an automatically assigned IP
address.
The IP address is obtained from a DHCP server. If it
can not, the IP address will default to addresses in the
169.254.x.x range.
• Use the following IP address: select this option to
manually assign a static IP address.
Enter the
Gateway
2. If you need to customize the hostname, enter it in the Hostname
field.
3. In the Control Ports area, you can specify which control ports are
used to access the device. You can enter any port number
between 1 and 65534. The default port numbers are:
• HTTP Port: 80
• HTTPS Port: 443
• RTSP Port: 554
4. In the NTP Server area, select how the device keeps time.
Avigilon cameras and encoders do not have an internal clock so it
uses a Network Time Protocol (NTP) server to keep time.
• Obtain NTP server via DHCP: select this option to
automatically use the same NTP server as the rest of the
network.
• Use the following NTP server: select this option to
manually set which NTP server is used.
5. Click Apply when you are done.
8
,
IP Address Subnet Mask
you want to use.
, and the
Default