Mounting Configurations; Mounting Brackets; Installing The Brackets For Rack Mounting - Paradyne BitStorm 4800 Express Installation Manual

1. Installation

Mounting Configurations

Three basic installation configurations are available:

Mounting Brackets

Your BitStorm 4800 Express can be installed in a rack or on the wall using
mounting brackets. Two brackets suitable for a 19-inch (483 mm) rack (marked
EIA-19) and two brackets suitable for a 23-inch (584 mm) Bay Networks or Nortel
rack (marked with Paradyne Part Number 868-6282-0020) are shipped with the
unit. Two brackets suitable for a 21-inch (535 mm) rack (marked ETSI) are
available from Paradyne as a separate feature (see
Rack-mounting brackets may also be used to attach the unit to a wall.

Installing the Brackets for Rack Mounting

Procedure
To install the mounting brackets for rack mounting:
1-6
Rack mount – see Installing the Brackets for Rack Mounting
Installing the BitStorm 4800 Express Into a Rack
Wall mount – see Installing the BitStorm 4800 Express on a Wall
page 1-10.
Shelf or desktop – see
Desktop on page 1-12.
NOTE:
In this guide, the term rack refers to any rack, cabinet, frame, or bay suitable
for mounting telecommunications equipment.
1. Locate the black screw nearest the front panel on each side of the unit, as
shown.
2. Remove these two black screws (one from each side) before attempting to
install the mounting brackets.
July 2004
Installing the BitStorm 4800 Express on a Shelf or
Appendix B, Equipment
on page 1-6 and
on page 1-8.
on
List).
4821-A2-GN21-10