Cables Required - Paradyne BitStorm 4800 Express Installation Manual

Cables Required

Table 1-2
Table 1-2.
4821-A2-GN21-10
shows all the cables that may be required for your installation.
Cable Descriptions
Connector Name Connector and Cable
DSL PORTS 1–24 50-pin RJ21X Telco-type
straight connector and 50-wire
DSL Ports 25–48 cable. Two cables required for
(if installed) 48-port model.
Port 2 8-position modular plug and
10/100BaseT 8-wire Category 5 or better
unshielded twisted pair (UTP)
cable.
Port 1 8-position modular plug and
10/100BaseT 8-wire Category 5 or better
unshielded twisted pair (UTP)
cable.
CONSOLE DB9 plug connector and
shielded cable.
The other connector
depends on the serial port on
your terminal or PC, but
normally is a DB9 socket.
The other connector
depends on the serial port on
your modem, but normally is
a DB25 plug. A null modem
(crossover) cable is required.
July 2004
1. Installation
For Connecting . . .
Up to 24 DSL ports per cable to
a POTS splitter.
The BitStorm 4800 Express to a
network.
A Network Management System
(NMS) over a Local Area
Network (LAN) employing
10BaseT or 100BaseT.
The BitStorm 4800 Express to
one of the following:
A terminal or a PC with a
terminal emulation program,
or
A modem.
1-3