Dsl Ports - Paradyne BitStorm 4800 Express Installation Manual

2. Cabling

DSL Ports

The BitStorm 4800 Express DSL connector supports the tip and ring connections
of up to 24 DSL ports over a 50-position cable. There are two DSL connectors on
the 48-port model.
You must connect the unit to a separate POTS splitter. The Model 6051 POTS
Splitter must be used for customer premises applications in Canada.
Procedure
To cable the DSL Ports:
2-2
1. Insert a cable tie (provided) through the top of the anchor mount next to the
DSL PORTS 1–24 connector.
2. If the connector for your cable has a short captive screw, attach the cable to
the DSL PORTS 1–24 connector and fasten it to the jack screw with its short
captive screw.
#4-40
Jack Screw
Short
Screw
50-Pin
Connector
3. If the connector for your cable has a long captive screw, remove the provided
jack screw from the threaded hole next to the DSL PORTS 1–24 connector.
Attach the DSL PORTS 1–24 connector to the unit using the long, captive
pan-head screw (provided).
4. Tighten the cable tie around the connector and trim the excess.
5. For a 48-port model, repeat
DSL Ports 25–48 for DSL PORTS 1–24.
July 2004
Anchor
Mount
02-17083
02-17084
Step 1 through Step 4, substituting
4821-A2-GN21-10