Snmp - Paradyne 6381-A3 User Manual

3. Using the Web Interface

SNMP

Use the SNMP (Simple Network Management Protocol) screen to enable and
configure the SNMP agent and SNMP trap managers.
The SNMP feature generates a trap whenever the IP address of the router
changes (except through the Troubleshooting Management Link). The trap sent
contains the following:
To configure SNMP:
Procedure
The Apply button will temporarily save these settings. To make the change
permanent, click on Tools and select System Commands. On the System
Commands page, click on Save All.
Figure 3-20. SNMP
3-24
Community (the community name configured for the trap destination, or
"public" if no community name was configured)
sysObjectID for the router
IP address of the agent sending the trap
Time stamp (sysUpTime)
Serial Number of the router
IP address of the router
Interface name
1. From the Home screen, click on Advanced and under Advanced, select SNMP.
The SNMP screen appears.
2. Enable the SNMP traps, then enter up to five Destination IP Addresses and
Community names.
January 2005 6381-A2-GB23-10