Headlamp Control - Volvo S90 Owner's Manual

Headlamp control

Use the light controls in the left-hand stalk
switch to activate external lighting. Use the
thumbwheel in the instrument panel to adjust
51
headlamp levelling and the brightness of the
interior lighting.
Rotating ring in the steering wheel stalk
switch
Applies to vehicles with halogen headlamps.
51
Position Specification
Daytime running lights when the
car's electrical system is in ignition
position II or when the car is run-
ning.
Main beam flash can be used.
Daytime running lights and position
lamps when the car's electrical sys-
tem is in ignition position II or when
the car is running.
Position lamps when the car is
A
parked .
Main beam flash can be used.
Dipped beam and position lamps.
Main beam can be activated.
Main beam flash can be used.
INSTRUMENTS AND CONTROLS
Position Specification
Daytime running lights and position
lamps in daylight when the car's
electrical system is in ignition posi-
tion II or when the car is running.
Dipped beam and position lamps in
weak daylight or darkness, or when
the front fog lamp* and/or rear fog
lamp are activated.
The Active main beam function can
be activated.
Main beam can be activated when
dipped beam is switched on.
Main beam flash can be used.
Active main beam on/off.
A Also at stationary when the car is running, provided that the
rotating ring is moved to this position from another position.
Volvo recommends that mode is used
when the vehicle is driven.
* Option/accessory, for more information, see Introduction.
}}
129