Table of Contents
Advertisement
Cables You May Need
The following cables and connectors are specifically for this product. See Warranty,
Sales, and Service Information on page 15 for ordering information. See the Technical
Reference for all cable pin-out information.
If connecting to a . . .
Terminal/printer (DB25
interface/connector – EIA-232
connection)
PC (DB9 interface/connector –
EIA-232 connection)
DTE with a V.35
interface/connector
DTE with a RS-449
interface/connector
DTE with a V.11/X.21
interface/connector
LAN Adapter
Modem (8-pin
modular-to-DB25 connector)
Recommended Order of Installation
1. First, install the I/O card.
2. Connect all cables into the I/O card.
3. Install the NAM.
4. Go to the appropriate housing installation document for power-up verification
procedures:
— 2-Slot Housing Installation Instructions (Document No. 9000-A2-GN15)
— 5-Slot Housing with AC Power Supply Installation Instructions (Document
No. 9000-A2-GN16)
— 5-Slot Housing with DC Power Supply Installation Instructions (Document
No. 9000-A2-GN1C)
— 9000 Series Access Carrier Installation Instructions (Document No.
9000-A2-GN1D)
You need a . . .
COM Port-to-Terminal/Printer cable (14 ft.)
COM Port-to-PC cable (14 ft.)
MS34 to DB25 adapter cable for each port: Port 1
and/or Port 2 (1 ft.)
DB37 to DB25 DTE adapter cable for each port:
Port 1 and/or Port 2 (1 ft.)
DB15 to DB25 adapter cable for each port: Port 1
and/or Port 2 (1 ft.)
COM Port-to-LAN Adapter cable (14 ft.)
Modem cable
3
Advertisement
Table of Contents
