Table of Contents
Advertisement
Tools Required
H
A small Phillips screwdriver (#1 or #2) to install the T1 NAM
H
A small, flat-blade screwdriver to install the:
— I/O card
— Cable connections
Installing the I/O Card
The NAM's I/O card provides the COM port, network, DSX and
DTE connections. The I/O card inserts directly behind the NAM
that it supports. Slot numbers are identical (in this case, Slot 01)
to facilitate correct installation.
1. Remove the I/O card from the shipping box. Handle only
by the top and bottom edges to avoid damaging the card.
2. At the rear of the housing, align the I/O card with the
upper and lower tracks of the slot. Push gently towards
the midplane until it stops and you cannot push the card
any further.
Access Carrier
Screws
3. There are two captive screws on the I/O card. Using a
screwdriver, alternately tighten each screw until the
screws are all the way in.
5-Slot
Screws
Screws
Rear View
4
Rear Panel
S I
N G
T 1
N E
D B
D S
2-Slot
P O
P O
97-15748a
C O
NAM
L E
N A
M
T
NET
DBM
(For
M
Future
Use)
DSX
X
Port 1
R T
1
Port 2
R T
2
COM
M
98-15050-03
Advertisement
Table of Contents
