Package Checklist; Wiring And Cables You Need - Paradyne Hotwire 5446 Installation Instructions Manual

Product-Related Documents
To install a POTS splitter, refer to the appropriate POTS splitter document:
Document Number
5030-A2-GN10
5038-A2-GN10
Contact your sales or service representative to order additional product documentation.
Paradyne documents are available on the World Wide Web at www.paradyne.com.
Select Library

Package Checklist

Verify that your package contains the following:
Model 5446 Remote Termination Unit (RTU)
DSL interface cable with RJ11 modular plugs
Power cord with power transformer
Refer to Cables & Connectors on page 14 for standard pin numbers.

Wiring and Cables You Need

The following wiring and standard connectors are used with this product:
Standard RJ11 wall jack.
DSL cabling: New or existing unshielded twisted-pair wiring (CAT3 or better).
The CAT3 wiring must meet EIA/TIA-568 specifications with 24 AWG (.5 mm) or
26 AWG (.4 mm).
Ethernet cabling: Standard Ethernet 8-pin, non-keyed modular plug for a PC or
workstation. An Ethernet straight-through or crossover cable is used. Refer to
Installing the Hotwire 5446 RTU on page 8 for Ethernet cable details.
After the RTU is installed and powered on, there are additional requirements in order to
utilize the DSL and Ethernet connections. Refer to Hotwire 5446 RTU IP Setup on
page 13.
Document Title
Hotwire 5030 POTS Splitter Customer Premises
Installation Instructions
Hotwire 5038 Distributed POTS Splitter Customer
Premises Installation Instructions
Technical Manuals Hotwire DSL and MVL Systems.
4