Table of Contents
Advertisement
Rear Panel Connections
The following connections are available on the rear panel. To setup the
remote interfaces, refer to Remote Interface Configurations on page 20.
N1913/1914A Installation Guide
1
7
6
No.
Connections
1
VGA Output (Option 010)
2
Ground Connector
3
USB Type A port (Option 008, Option 009)
This USB port is solely for U2000 Series power sensors usage only.
4
Recorder 1/2
Recorder output (two outputs are fitted to dual channel meters) connections are
made via BNC connectors. This output produces a DC voltage that corresponds
to the power level of the channel input.
5
AC Inlet
This power meter has an auto configuring power supply. This allows it to operate
over a range of voltages without manually being set to a certain voltage.
6
Trig In/Trig Out
Trigger input and output connections are made via BNC connectors.
7
USB Mini-B port
This USB port is used for remote interface connection.
8
LAN
9
GPIB
This connector allows the power meter to be controlled remotely using the
General Purpose Interface Bus.
3
4
2
8
9
Getting Started
5
1
19
Advertisement
Table of Contents
