Remote Interface Configurations - Agilent Technologies N1913a Installation Manual

Epm series power meters

Hide thumbs Also See for N1913a:

Table of Contents

Getting Started

Remote Interface Configurations

The power meter can be remotely controlled by LAN, USB, and GPIB

(IEEE488) programming interfaces. This section shows you how to set the

interface configurations.

Only one interface should be used at any one time.

To connect the power meter to your PC, configure and verify your connection, you can use

N O T E

the Agilent IO Libraries Suite, the E2094M Agilent IO Libraries for Windows, or an

equivalent.

• Agilent IO Libraries Suite for Windows 98/2000/ME/XP. For information

• E2094M Agilent IO Libraries for Windows 98/NT/2000/ME/XP. You can

• You can also access other information about Agilent IO Libraries at

For more information on configuring the remote interface connectivity,

refer to the Agilent Technologies USB/LAN/GPIB Interfaces Connectivity

Guide. If you have installed the IO Libraries Suite, you can access the

connectivity guide via the Agilent IO Libraries Control icon. Alternatively,

you can access the connectivity guide via the Web at

www.agilent.com/find/connectivity.

and to install, use the Automation- Ready CD with Agilent IO Libraries

Suite which is shipped with the power meter.

find information and install this application via the Web at

www.agilent.com/find/iolib.

N1913/1914A Installation Guide

Table of Contents

N1914a