Table of Contents
Advertisement
1
Getting Started
Introduction
The Agilent N1913/1914A EPM Series Power Meter Installation Guide shows
you how to:
• physically check the power meter.
• adjust the carrying handle.
• switch it on and confirm the meter passes the power- on self test
• connect it to a U2000 Series power sensor.
• connect it to a 8480, N8480 Series or E- Series power sensor.
• perform a zero and calibration routine on a 8480, N8480 Series, or
• perform a zero routine on U2000 Series power sensors.
• make connections to the rear panel.
• use the Agilent IO Libraries Suite to configure the remote programming
• attach the rack mounting kits (supplied with Option 908 or Option 909).
Both single and dual channel power meters with a variety of rear panel configurations have
N O T E
been used for the illustrations in this guide. Your power meter may differ in details to those
shown.
Initial Inspection
Please inspect the shipping container for damage. If the shipping container
or packaging material is damaged, it should be kept until the contents
have been checked mechanically and electrically. If there is mechanical
damage, notify the nearest Agilent Technologies office. Keep the damaged
shipping materials (if any) for inspection by the carrier and an Agilent
representative. If required, you can find a list of Agilent Sales and
Service Offices.
Please ensure you have read and understood the preceding safety
information before you proceed.
2
E- Series power sensor.
interfaces.
N1913/1914A Installation Guide
Advertisement
Table of Contents
