Table of Contents
Advertisement
LAN
The power meter has three LAN operating modes:
• Dynamic IP (Dynamic Host Configuration Protocol or DHCP)
• Auto IP (Local PC Control or isolated (non- site) LAN)
• Static IP (Manual mode)
Your power meter uses standard VXI-11 protocol for emulating GPIB over a TCP/IP link. The
N O T E
emulated GPIB address is fixed at 15.
Configuring the Power Meter
• The IP address, subnet mask, and default gateway, can be changed
• The IP address, subnet mask, and default gateway values are stored in
Selecting the LAN Network Type
You can connect and configure your power meter for site LAN or isolated
(non- site) LAN.
A site LAN network is defined as a local area network (LAN) in which
computers and LAN- enabled instruments are connected to a site LAN
(workgroup LAN, intranet, or enterprise LAN) via optional routers, hubs,
and/or switches.
An isolated (non- site) LAN network is defined as a local area network
(LAN) in which computers and LAN- enabled instruments are not con-
nected to a site LAN.
Select the LAN network type you will use to connect the power meter to
your computer. Then follow the procedure that corresponds to your
selected LAN network type.
N1913/1914A Installation Guide
manually or remotely.
non- volatile memory and are not part of the save- recall function.
Getting Started
1
23
Advertisement
Table of Contents
