NETGEAR D6300 User Manual page 45

- Single PC - no Subnet. Select this option if there is no LAN (only a single
computer) at the remote endpoint.
If this option is selected, no additional data is required.
- Single address. Enter an IP address in the Single/Start IP address field.
This value must be an address on the remote LAN. Typically, this setting is used
when you wish to access a server on the remote LAN.
- Range address. Enter the starting IP address in the Single/Start IP address field,
and the finish IP address in the Finish IP address field.
This range must be an address range used on the remote LAN.
- Subnet address. Enter an IP address in the Single/Start IP address field, and the
desired network mask in the Subnet Mask field.
The remote VPN endpoint must have these IP addresses entered as its local
addresses.
• IKE.
- Direction/Type. This setting is used to determine if the IKE policy matches the
current traffic. Select the desired option.
- Responder only. Incoming connections are allowed, but outgoing connections
are blocked.
- Initiator and Responder. Both incoming and outgoing connections are allowed.
- Exchange Mode. Currently, only Main Mode is supported. Ensure that the remote
VPN endpoint is set to use Main Mode.
- Diffie-Hellman (DH) Group. When the VPN connection keys are exchanged, the
Diffie-Hellman algorithm is used. The DH Group setting determines the bit size
used in the exchange. This value must match the value used on the remote VPN
gateway.
- Local Identity Type. Select the desired option to match the Remote Identity Type
setting on the remote VPN endpoint.
- WAN IP Address. Your Internet IP address.
- Fully Qualified Domain Name. Your domain name.
- Fully Qualified User Name. Your name, email address, or other ID.
- Local Identity Data. Enter the data for the selection. When WAN IP Address is
selected, no input is required.
- Remote Identity Type. Select the desired option to match the Local Identity Type
setting on the remote VPN endpoint.
- IP Address. The Internet IP address of the remote VPN endpoint.
- Fully Qualified Domain Name. The domain name of the remote VPN endpoint.
- Fully Qualified User Name. The name, email address, or other ID of the remote
VPN endpoint.
D6300 WiFi DSL Modem Router
NETGEAR genie ADVANCED Home
45