Configuration Examples; Stereo Operation - Eton PA 1502 Installation & Operation Manual

Configuration Examples

Stereo Operation

Place the connections as shown in the diagram.
SOURCE UNIT
12V
switched
Filter Selection Full Range Amplifier
Place the switches of HP and LP filters (15; 17) in the OFF position
Place the switch (9) in the STEREO position
Place the switch (13) phase in the OFF position
The amplifier now operates in a full range amplifier mode. The entry signal is amplified, but the frequency
range remains unchanged.
Bass Boost
The bass reproduction can be increased at 45 Hz between 0 and 12 dB. Simply turn the controller (12) until
your listening taste has been satisfied
Filter Selection HP
Place switch 17 in the ON position. Now you can select the transmission frequency of the amplifier between
16 and 160 Hz by using controller HP (18). Depending upon the position of the controller the amplification of
the signal will begin at 16 Hz (the lowest) up to 160 Hz (the highest).
This operational mode is recommended when you operate your front system in addition to a subwoofer. With
this configuration you can relieve your front system of the necessity of transmitting the low frequencies and
at the same time operate the subwoofer without overlapping frequencies.
20
Tweeter
Woofer
Left
(High Pass)
Tweeter
Woofer
Right
FUSE