Before Putting Into Operation; Installation; Mounting - Eton PA 1502 Installation & Operation Manual

Before Putting into Operation

Hint
The installation and adjustment of the amplifier should only be entrusted to qualified personnel.
Please carefully read the operation instructions and follow the given directions regarding connection and
adjustment of the amplifier.
Warning
Before connecting external devices that do not belong to this amplifier, please refer to the
corresponding directions contained in the operation instructions for this device.
Warning
Under no circumstances should you open the amplifier or attempt any repairs. If required contact
your dealer to obtain technical assistance. Unauthorized changes will result in the cancellation of
warranty.

Installation

Warning
The amplifiers are exclusively designed for the interior of vehicles with a power supply of 12 volt
DC (Direct Current). The surrounding temperature may vary from 0° to 60° Centigrade.
Attention
Install the amplifier only in the interior of the vehicle or in the trunk. Never install the amplifier in
the motor space under the hood.
Warning
The amplifier must not be subjected to pressure and not be covered.
Warning
Be careful that no foreign object or fluid can enter the amplifier. Be sure the amplifier is provided
with sufficient air circulation to achieve proper cooling of the cabinet.

Mounting

Warning
The amplifier should be mounted in a vertical position within an area of the vehicle that allows
good air circulation.
Attention
The heat sinking device can reach a temperature over 80° Centigrade. Be careful to avoid contact
with temperature sensitive surfaces or materials.
Attention
Be sure that no components are close to the mounting position of the amplifier that could be
damaged by the screws or during the mounting procedure.
Damage to the vehicle can severely endanger the automobile safety as well as the safety of
the passengers.
Attention
Mount the amplifier using the four fastening clips. Be careful that you choose a strong, stable
surface that can carry the weight of the device. Avoid mounting on plastic parts or cardboard lining.
14