Components And Assembly; Controls And Functions; Tools Needed For Assembly - WAGNER Airless Sprayer Plus 0418 Operating Instructions Manual

Airless Sprayer Plus
Components
•
Spray gun with filter
•
Spray tip assembly
•
10 mtr. long, 1/4 Zoll diameter high pressure hose.

Tools needed for assembly

•
Two adjustable wrenches.
WARNING
Do not plug in the unit until setup is complete.
Handle
Return
tube
Hopper
Frame
Outlet
valve
Tip
storage
Tip guard
Assembly
1
Place the handle over the unit frame.
Insert the bolts and tighten the wing
nuts over the lock washers.

COMPONENTS AND ASSEMBLY

Spray
gun
Trigger lock
Tip
Filter (yellow)
preassembled
Trigger
in gun
2
Thread one end of the high pressure spray
hose to the outlet valve.
Tighten with an adjustable wrench.

Controls and functions

ON/OFF switch
Spray Gun
Spray Hose
Return Tube
PRIME/SPRAY knob
Inlet filter
(inside of hopper)
Hopper lid
Motor
housing
Rear
handle
ON/OFF
switch
Inlet valve
tool
PRIME/SPRAY
knob
Filter
(red)
Spray
hose
The ON/OFF switch turns the unit
on and off (O = OFF, l = ON)
The spray gun controls the
delivery of the fluid being
pumped.
The spray hose connects the gun
to the pump.
Fluid is sent back out through the
return tube to the hopper when
priming.
The PRIME/SPRAY knob directs
fluid to the spray hose when set
to SPRAY, or the return tube when
set to PRIME.
ON/OFF Switch
PRIME/SPRAY
PRIME
position
SPRAY
SPRAY
position
3
Thread the other end of the hose to
the spray gun. Hold the gun with one
adjustable wrench, and tighten the
hose nut with the other.
GB
= ON
= OFF
knob
23