Components And Assembly; Specifications - WAGNER Paint Crew 770 Owner's Manual

Specifications

Weight..............................25 lbs.
Capacity ..........................2 gallon hopper
Power source..................3/8 Hp universal motor
Power requirement.........15 amp minimum circuit on 120 VAC,
60 Hz current.
Generator ........................8000 Watt.
Max. spraying pressure ...2800 PSI
Safety features: Spray gun trigger lock and pressure diffuser;
built-in tip safety guard; PRIME/SPRAY knob for safe pressure
release. Conforms to UL STD 1450. Certified to CAN/CSA C
22.2 NO 68-92.
Capability: Sprays a variety of paints, latex, primers, stains,
preservatives and other nonabrasive materials, including
pesticides and liquid fertilizers. Do not use materials with
flash points below 70°F (21°C).
This pump should not be used with textured materials, block filler, lacquers, industrial enamels, or asphalt sealer or
materials containing HHC. See coating supplier if flash point is not listed on the container.
Handle
Inlet filter
(inside of
hopper)
Return tube
Hopper
Outlet
valve
Tip storage
Do not plug in the unit until setup is complete.
1. Place the handle over the unit
frame. Insert the bolts and tighten
the wing nuts over the lock washers.
English

Components and Assembly

Components / Assembly
PRIME/SPRAY knob
2. Thread one end of the high pressure
spray hose to the outlet valve.
Tighten with an adjustable wrench.
Controls and Functions
ON/OFF Switch:
The ON/OFF switch turns the power to the sprayer on and
off (O=OFF, l=ON).
Spray Gun:
The spray gun controls the delivery of the fluid being
pumped.
Spray Hose:
The spray hose connects the gun to the pump.
Return Tube:
Fluid is sent back out through the return tube to the original
container when PRIME/SPRAY knob is in PRIME position.
PRIME/SPRAY Knob:
The PRIME/SPRAY knob directs fluid to the spray hose
when set to SPRAY or the return tube when set to PRIME.
The PRIME/ SPRAY knob is also used to relieve pressure
built up in the spray hose (see
page 5).
Hopper lid
Spray guard Spray tip
Rear handle
ON/OFF switch
Inlet valve tool
3. Thread the other end of the hose to the
4
Pressure Relief Procedure,
Spray gun
Spray hose
spray gun. Hold the gun with one
adjustable wrench, and tighten the hose
nut with the other.