WAGNER Airless Sprayer Plus 0418 Operating Instructions Manual page 30

GB
Short-term storage (up to 8 hours)
Shutdown
1) Perform all the steps of the PRESSURE RELIEF
PROCEDURE (page 24).
2) Pour 1/2 cup water slowly on top of the paint to prevent
it from drying. Replace the hopper lid.
3) Wrap the spray gun assembly in a damp cloth and place
it in a plastic bag. Seal the bag shut.
4) Unplug the sprayer.
5) Place the sprayer in a safe place out of the sun for
shortterm storage.
Startup
1) Remove the gun from the
plastic bag and stir the water
into the paint.
2) Check to be sure the PRIME/
SPRAY knob is set to PRIME.
3) Plug sprayer in and turn the
switch to ON.
4) Turn the PRIME/SPRAY knob
to SPRAY.
5) Test the sprayer on a
practice piece and begin
spraying.
30
STORAGE
SPRAY
Airless Sprayer Plus
Preparing the sprayer for longterm storage
1) Make sure you have already completed the Cleanup
steps on pages 28-29.
2) Remove the inlet filter. You may need to use a screwdriver
to pry it loose.
Inlet
filter
3) Pour approximately two ounces of light household oil
into the inlet valve.
Inlet
valve
4) Remove hose from outlet valve, place a rag over the
outlet valve, and turn the switch ON. Let the unit run
for five seconds.
5) Switch the pump OFF.
6) Replace the inlet filter and push the tab on the filter.
7) Wipe the entire unit, hose and gun with a damp cloth to
remove accumulated paint.
8) Replace the high pressure hose to the outlet valve and
replace the hopper lid.
Tab