To Connect Additional "Wired" Computers; To Connect A Network Device - Zoom 5590 Quick Start Manual

To Connect Additional "Wired"
Computers
You can connect up to four computers with Ethernet ports directly
to the X6.
1 1 1 1
Shut down the computer you want to add to the X6. (This is
important because the computer must locate the correct IP
address for the modem. This is done when the computer is
turned back on in step 3 below.)
2 2 2 2
Plug one end of an Ethernet cable into one of the modem's
LAN ports and plug the other end into your computer's
Ethernet port.
3 3 3 3
Turn on the computer.
4 4 4 4
Verify that your Internet connection is working. Open your
Web browser (i.e., Internet Explorer or Netscape Navigator)
and try to connect to a familiar Web address.
5 5 5 5
Repeat steps 1–4 for each computer you want to add.

To Connect a Network Device

You can use one of the LAN ports on the X6 to plug in a network
device (for example, hub, switch, or router).
1 1 1 1
Plug one end of an Ethernet cable into one of the modem's
LAN ports and the other end into the network device's
Ethernet port. (For a hub or a switch, this is typically called an
Uplink or Expansion port. For a router, this is typically called a
WAN port.)
2 2 2 2
Set up your network. Refer to the documentation provided
with your particular network device for instructions on how to
do this.
12 ADSL X6 Quick Start