Connecting The Power; Connecting A Phone To The Network - Cisco UC320W Administration Manual

Connecting the Power

Connecting a Phone to the Network

STEP 1
STEP 2
NOTE
If you are using an external power source, insert one end of the power cord into an
outlet and insert the other end of the power cord into the power port on the phone
body.
Connecting a Phone with an Ethernet Cable
Insert one end of the Ethernet cable into the network port on the phone body
marked "SW."
Insert the other end of the Ethernet cable into a LAN port of the Cisco UC320W or
into a LAN port on an Ethernet switch.
On all models excepts Cisco SPA301, you can connect a PC to the phone's second
Ethernet port (see Phone Connections, page
phone is connected the LAN with an Ethernet cable, but not when the phone is
operating wirelessly.
Connecting a Cisco SPA525G/G2 Model Phone to the
UC320W Wireless Voice Network
If you enable the wireless voice network in the UC320W configuration utility, Cisco
SPA525 models can be used wirelessly. The wireless profile will be added to the
phone during the initial configuration.
IMPORTANT: For initial configuration of the phone, use an Ethernet cable. After
entering the settings, including the wireless network settings, apply the
configuration in the UC320W configuration utility. Wait for all devices to reboot and
reinitialize. At that point, you can begin this procedure.
Follow this procedure to verify that your phone is connected to the UC320W
wireless network. This procedure also explains how to connect to the network if
the wireless connection is not made automatically.
64). This port can be used when the
73