Cisco UC320W Administration Manual page 74

If an Ethernet cable is connected to the phone, remove it and wait for the phone to
STEP 1
reboot. If an Ethernet connection is present on the phone, it is used instead of the
Wi-Fi connection.
Press the Setup button on your phone.
STEP 2
Scroll to Network Configuration and press Select.
STEP 3
In the Wi-Fi field, confirm that there is check mark to indicate that Wi-Fi is On. If the
STEP 4
check mark does not appear, press the left-arrow or right-arrow navigation button
to enter a check mark in the field.
Select Wireless Profile. The display should show that the phone is connected the
STEP 5
wireless voice network of your UC320W.
If the connection is not shown, complete the following tasks to connect to the
NOTE
wireless network by using Wi-Fi Protected Setup.
a. Press the down-arrow navigation button to move the cursor to Wi-Fi
Configuration.
b. Press the right-arrow navigation button to open the Wi-Fi Configuration menu.
c. Select Wi-Fi Protected Setup. The Select the WPS Mode window appears.
d. Select Push Button Configuration. The Push Button Configuration instructions
appear.
e. On the front panel of the UC520W, press the Wi-Fi Protected Setup (WPS)
button.
f. On the phone, press Select. The phone displays a message: Connecting to AP.
The phone may reboot before the Wi-Fi connection is working.
The PC port is not supported in wireless operation. A PC can be connected to the
NOTE
port only when an Ethernet cable is connected to the phone.
74