Unpacking Instructions - 3Com CoreBuilder 9000 Quick Installation Manual

Unpacking Follow these steps:
Instructions
1 Place the chassis shipping box near the rack, the table, or the shelf
where you plan to install the chassis.
2 Cut the tape that covers the seam on the top of the box.
WARNING: Safety regulations state that the selected table, shelf, or
rack must be able to support at least three times the weight of a fully
loaded chassis. A fully loaded 7-slot chassis weighs approximately
38.56 kg (85 lb). Therefore, the selected table or shelf must support at
least 115.6 kg (255 lb).
3 Remove the following items (Figure 2) from the inner tray:
One hardware kit in a plastic bag (Part Number 10002489 HDW)
One documentation kit that contains:
Four plastic feet to mount to the bottom of the chassis (for a
tabletop installation)
Four 6-32 Phillips-head screws to mount the feet
Twelve rack-mount clips for a rack-mount installation
Twelve 10-32 Phillips-head screws to attach the chassis to the
rack
The 7-Slot Chassis Quick Installation Guide for the
CoreBuilder 9000 Enterprise Switch (this guide)
The CoreBuilder 9000 Enterprise Switch Getting Started Guide
The 7-Slot Chassis Power Supply Installation Guide for the
CoreBuilder 9000 Enterprise Switch
The CoreBuilder 9000 Documentation Overview sheet
7-Slot Chassis Quick Installation Guide 3