Installing The Inverter; Opening The Connection Area - Kaco Powador 30.0 TL3 M/XL Operating Instructions Manual

I n sta l li ng the Inve rt e r
Authorised electrician
Installing the hood
↻ Remove the EMC sheet metal.
1. Place the hood on the top side of the housing.
2. Secure the hood to the inverter housing from the inside using the enclosed fastening screws.
» Install the side housing covers.
Installing the side housing covers
↻ Remove the EMC sheet metal.
1. Place the left housing cover on the inverter housing.
2. Secure the left housing cover to the inverter housing from the inside using the 2 enclosed M4 x 10 screws.
3. Place the right housing cover on the inverter housing.
4. Secure the right housing cover to the inverter housing from the inside using the 2 enclosed M4 x 10 screws
with a Torx T30 screw driver.
» Place the EMC sheet metal on the housing.
Placing the EMC sheet metal on the housing
1. Place the EMC sheet metal on the inverter housing.
2. Secure the EMC sheet metal to the inverter housing using the enclosed 25 M4 x 10 screws.
» The mounting of the inverter is complete.
» Continue with the installation.
7

Installing the Inverter

DANGER
Lethal voltages are still present in the terminals and cables of the inverter even after the
inverter has been switched off and disconnected.
Severe injuries or death will occur if the cables and terminals in the inverter are touched.
Only authorised electricians who are approved by the supply grid operator may open and install the
inverter.
The inverter must be mounted in a fi xed position before being connected electrically.
› Observe the safety regulations and current technical connection specifi cations of the responsible
power supply company.
› Disconnect the AC and DC sides.
› Secure both sides against being inadvertently switched back on.
› Ensure that the AC and DC sides are completely voltage-free.
› Connect the inverter only after the aforementioned steps have been taken.
7.1

Opening the connection area

Opening the connection area
↻ You have mounted the inverter.
1. Unlock the door locks.
2. Open the door.
3. Remove the cover of the connection area.
» Make the electrical connection.
Page 20 Operating Instructions Powador 30.0-39.0 TL3_EN