Installing The Inverter; Opening The Connection Area - Kaco Powador Operating Instructions Manual

Installing the inverter

Authorised electrician
Installing the side housing covers
EN EN
Remove the EMC sheet metal.
1. Place the left housing cover on the inverter housing.
2. Secure the left housing cover to the inverter housing from the inside using the 2 enclosed M4 x 10 screws.
3. Place the right housing cover on the inverter housing.
4. Secure the right housing cover to the inverter housing from the inside using the 2 enclosed M4 x 10 screws
with a Torx T30 screw driver.
» Place the EMC sheet metal on the housing.
Placing the EMC sheet metal on the housing
1. Place the EMC sheet metal on the inverter housing.
2. Secure the EMC sheet metal to the inverter housing using the enclosed 25 M4 x 10 screws.
» The mounting of the inverter is complete.
» Continue with the installation.
7 Installing the inverter
Lethal voltages are still present in the terminals and cables of the inverter even after the
inverter has been switched off and disconnected.
Severe injuries or death result if the cables and terminals in the inverter are touched.
Only appropriately qualified and authorised electricians may open and install the inverter.
The inverter must be mounted in a fixed position before being connected electrically.
›
›
›
›
›
7.1

Opening the connection area

Opening the connection area
You have completed assembly.
1. Unlock the two door locks with the control cabinet key.
2. Open the doors.
3. Remove the cover of the connection area.
» Make the electrical connection.
Page 18
DANGER
Observe all safety regulations and current technical connection specifications of the responsible
power supply company.
Disconnect the AC and DC sides.
Secure both sides against being inadvertently switched back on.
Ensure that the AC and DC sides are completely isolated and voltage free.
Connect the inverter only after the aforementioned steps have been taken.
Operating Instructions for Powador 30.0-72.0 TL3_EN