Table of Contents
Advertisement
5.6
How to Reset Emergency Stop
5.6
How to Reset Emergency Stop
The machine stops in an urgent manner in the following cases. Go to the corresponding operation.
Cause
EMERGENCY STOP on the control panel of Roll
Winder RW-101/Roll Winder RW-201 is pressed.
Abrupt stop of power
supply (circuit off)
The sub power switch is turned off.
)If JAM code J-5102 is displayed
If JAM code [J-5102] is displayed, clear the jam following the instructions described below.
A
Remove paper from inside the main body, and then open and close the front door of
the main body.
For instructions on how to remove paper, refer to page 5-12.
B
Check the status of Roll Winder RW-101 or Roll Winder RW-201, then clear errors
or the emergency stop status.
For details, refer to the HTML User's Guide.
5-30
Main body and Roll
Winder RW-101/Roll
Winder RW-201
Main body
Only for Roll Winder RW-
101/Roll Winder RW-201
How the machine stops
The machine stops with
the JAM code J-5102 dis-
played.
The main body and Roll
Winder RW-101/Roll
Winder RW-201 stop im-
mediately.
The main body stops im-
mediately and Roll Wind-
er RW-101/Roll Winder
RW-201 stop convey-
ance.
The machine stops with
the JAM code J-5102 dis-
played.
The machine stops as
soon as the current job is
done.
Operation to reset
To "If JAM code J-5102 is
displayed"
To "Recover from Abrupt
Stop of Power Supply"
To "Recover from Abrupt
Stop of Power Supply"
To "If JAM code J-5102 is
displayed"
To "Recover from Abrupt
Stop of Power Supply"
Advertisement
Table of Contents
