Changing The Media Tension - Konica Minolta C71cf Quick Manual

5.5 A media feeding error occurs

)Changing the media tension

If media meandering is not solved, raise the tension by one level from the current setting according to the table below.
For details about changing the media tension, refer to page 3-15.
Tips
Before changing the media tension, perform the following: For details, refer to page 5-17.
-
Check the media tension
- Check the Position of the Media and Parts
- Clean Adhesive sticking on the Parts
-
Adjusting the aligning roller
Level
Lower the ten- 1
sion
2
+
3
4
5
,
6
Raise the ten-
7
sion
Level 7 is only used when paper width is 250 mm. For details about the media tension setting, refer to "User's
Guide[User Maintenance]/[Handling paper]".
5-20
Position of the Aligning Roll-
Tension Roller er
2
Bottom Rotate
Bottom Rotate
Top Rotate
Top Rotate
Top Fix
Top Fix
Top Fix
Position of the Air Level of the
Tension Roller Paper Feed
4 Loop Fan
Bottom Weak
Bottom Strong
Bottom Weak
Bottom Strong
Bottom Weak
Bottom Strong
Top Strong