Changing The Media Tension - Konica Minolta C71cf Quick Manual

)Changing the media tension

If jam code J-3105 is repeatedly displayed, lower the tension by one level from the current setting according to the
table below.
For details about changing the media tension, refer to page 3-15.
Tips
Before changing the media tension, perform the following: For details, refer to page 5-28.
- Check the media tension
-
Check the Position of the Media and Parts
- Clean Adhesive sticking on the Parts
Level
Lower the ten- 1
sion
2
+
3
4
5
,
6
Raise the ten-
7
sion
Level 7 is only used when paper width is 250 mm. For details about the media tension setting, refer to "User's
Guide[User Maintenance]/[Handling paper]".
Position of the Aligning Roll-
Tension Roller er
2
Bottom Rotate
Bottom Rotate
Top Rotate
Top Rotate
Top Fix
Top Fix
Top Fix
bizhub PRESS C71cf
Position of the Air Level of the
Tension Roller Paper Feed
4 Loop Fan
Bottom Weak
Bottom Strong
Bottom Weak
Bottom Strong
Bottom Weak
Bottom Strong
Top Strong
5
5-29