3.2
Changing the Media
3.2
Changing the Media
This section describes how to change the media by adding the media with using the workbench of Roll Winder RW-
101.
Operate the following procedures to replace the media.
Before changing the media, prepare the following items.
-
Cutter knife
-
Masking tape (width more than 30 mm / 1.18")
-
Ruler
-
Phillips screwdriver and other tool
-
Lifter
NOTICE
NOTICE
Before setting or changing the media, turn on the main power switch and sub power switch of the main body, and
the power switch of Roll Winder RW-101/Roll Winder RW-201.
Reference
For details on how to set the media, refer to the HTML User's Guide.
■ Workflow
Set the Media to the Feeding Shaft: page 3-3
Connect the Media Using the workbench: page 3-7
Adjust the Media Tension: page 3-10
Convey the Media: page 3-19
3-2