Operating Procedures - Jacobsen R-311 Operation Manual

4 OPERATION
4.3

OPERATING PROCEDURES_________________________________________________

A folding Roll Over Protection Structure (ROPS) is included with this mower. Seat belts must be worn whenever
operating the mower with the ROPS in the raised and locked position. Always keep seat belt snugly adjusted. DO
NOT use seat belts with the ROPS folded. See Section 4.12.
If the mower is overturning and the ROPS in the raised and locked position, hold onto the steering wheel. Do not
attempt to jump out or leave the seat.
To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection.
1. Under no circumstances should the engine be
started without the operator seated on the mower.
2. Do not operate mower or attachments with loose,
damaged, or missing
possible mow when grass is dry.
3. First mow in a test area to become thoroughly
familiar with the operation of the mower and control
levers.
4. Study the area to determine the best and safest
operating procedure. Consider the height of the
grass, type of terrain, and condition of the surface.
Each condition will require certain adjustments or
precautions.
5. Never direct discharge
bystanders, nor allow anyone near the machine
while in operation.
responsible for injuries inflicted to bystanders and/or
damage to their property.
!
CAUTION
Before mowing, pick up all debris such as rocks, toys,
and wire which can be thrown by the machine. Enter a
new area cautiously. Always operate at speeds that
allow you to have complete control of the mower.
6. Use discretion when mowing near gravel areas
(roadway, parking areas, cart paths, etc.). Stones
discharged from the implement may cause serious
injuries to bystanders
equipment.
7. Always turn PTO switch OFF to stop blades when
not mowing.
16
!
WARNING
!
CAUTION
components. Whenever
of material toward
The owner/operator
and/or damage the
8. Disengage the drive motors and raise the decks
when crossing paths or roadways. Look out for
traffic.
9. Stop and inspect the equipment for damage
immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
!
Before you clean, adjust, or repair this equipment,
always disengage all drives, lower implements to the
ground, engage parking brake, stop engine, and
remove key from ignition switch to prevent injuries.
10. Slow down and use extra care on hillsides. Read
Section 4.8. Use caution when operating near drop
is
offs.
11. Look behind and down before backing up to be sure
the path is clear. Use care when approaching blind
corners, shrubs, trees, or other objects that may
obscure vision.
12. Never use your hands to clean blades. Use a brush
to remove grass clippings from blades. Blades are
extremely sharp and can cause serious injuries.
WARNING