Operating Procedures - Jacobsen LF 550 67979 Safety & Operation Manual

4 OPERATION
4.3

OPERATING PROCEDURES_________________________________________________

A Roll Over Protection Structure (ROPS) is included with this mower. Seat belts must be worn whenever operating
a mower with a ROPS. Always keep seat belt snugly adjusted. DO NOT use seat belts on a mower without a ROPS.
If the mower is overturning, hold onto the steering wheel. Do not attempt to jump out or leave the seat.
To prevent injury, always wear safety glasses, leather work shoes or boots, a hard hat, and ear protection.
1. Under no circumstances should the engine be
started without the operator seated on the mower.
2. Do not operate mower or attachments with loose,
damaged, or missing
possible mow when grass is dry.
3. First mow in a test area to become thoroughly
familiar with the operation of the mower and control
levers.
NOTICE
Never operate the reels unless they are mowing
grass. Heat will develop between the bedknife and
reel and damage the cutting edge.
4. Study the area to determine the best and safest
operating procedure. Consider the height of the
grass, type of terrain, and condition of the surface.
Each condition will require certain adjustments or
precautions.
5. Never direct discharge
bystanders, nor allow anyone near the machine
while in operation.
responsible for injuries inflicted to bystanders and/or
damage to their property.
!
CAUTION
Before mowing, pick up all debris such as rocks, toys,
and wire which can be thrown by the machine. Enter a
new area cautiously. Always operate at speeds that
allow you to have complete control of the mower.
6. Use discretion when mowing near gravel areas
(roadway, parking areas, cart paths, etc.). Stones
discharged from the implement may cause serious
injuries to bystanders
equipment.
7. Always turn mow switch OFF to stop blades when
not mowing.
16
!
WARNING
!
CAUTION
components. Whenever
of material toward
The owner/operator
and/or damage the
8. Disengage the drive motors and raise the reels
when crossing paths or roadways. Look out for
traffic.
9. Stop and inspect the equipment for damage
immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the
equipment repaired before resuming operation.
Before you
equipment, always disengage all drives, lower
implements to the ground, engage parking brake
switch, stop engine, and remove key from ignition
switch to prevent injuries.
10. Slow down and use extra care on hillsides. Read
Section 4.11. Use caution when operating near
drop offs.
11. Look behind and down before backing up to be sure
the path is clear. Use care when approaching blind
corners, shrubs, trees, or other objects that may
obscure vision.
is
12. Never use your hands to clean cutting units. Use a
brush to remove grass clippings from blades. Blades
are extremely sharp and can cause serious injuries.
!
WARNING
clean, adjust, or repair this