Control Panel Switches; Gauges And Circuit Breakers - Jacobsen R-311 Operation Manual

3 CONTROLS
3.4

CONTROL PANEL SWITCHES _______________________________________________

N. PTO Switch
Lift up and push switch lever forward to engage
decks and switches (O and P). Pull switch lever back
to disengage.
O. Wing Deck Switch
Used to engage or disengage both wing decks.
Depress front of switch to engage decks. Return
switch to center position to disengage decks.
Pressing rear of switch has no function. PTO switch
(N) must be engaged and cutting units lowered for
switch to operate.
P. Front Deck Switch
Used to engage or disengage front deck. Depress
front of switch to engage deck. Return switch to
center position to disengage deck. Pressing rear of
switch has no function. PTO switch (N) must be
engaged and cutting units lowered for switch to
operate.
Q. Light Switch (Optional)
Press front of switch for road lights. Press rear of
switch for work lights. Return switch to center
position to shut off lights.
3.5

GAUGES AND CIRCUIT BREAKERS __________________________________________

V. Warning Lights
Alerts the operator to conditions requiring immediate
action. See Section 3.6.
W. Fuel Gauge
Displays fuel level in tank. Do not allow mower to run
out of fuel.
X. Voltmeter
Displays electrical system voltage.
Y. Hour Meter
Records engine operating hours. The hour meter can
be used to time maintenance intervals or mowing
operations.
12
O
N
L
K
J
P
M
R
Q AA
˚ F
200
170 93
77
˚ C
SOLID STATE
HOURS
0 0 0 0 0
10 10
10 10
T
S
U Y
R. 2WD / 4WD Switch
Used to switch mower between 2WD and 4WD
mode. Depress front of switch for 4WD in forward
direction only. Place switch in center position for
2WD. Depress rear of switch for momentary 4WD in
reverse. Do not engage or disengage 4WD while
mower is moving.
S. Cruise Control Switch
Depress traction pedal for desired speed and press
front of switch to engage cruise control. Depress
service brake pedal or press rear of switch to
disengage cruise control.
T. Ignition Switch
Used to start and stop the engine. The ignition switch
has three positions OFF, RUN, and START. To
prevent unauthorized use of this mower, remove
ignition key when not in use.
U. Glow Plug Switch
Used to energize the glow plugs before starting. Do
not hold switch for more than 7 seconds. Glow Plug
light will be on when switch is depressed.
Z. Circuit Breakers
Used to protect electrical system. Push down on
rubber boot to reset circuit breaker.
AA.Temperature Gauge
Displays engine coolant temperature. Do not operate
mower if temperature is above 230° F (110° C).
V
W
12 14
10 16
VOLTS
10 30 30 10
X
10 30 30 10
J-T XXXXXX-XX
Z