Control Panel Switches; Gauges And Circuit Breakers - Jacobsen R-311T Dealer's Manual

2.4

CONTROL PANEL SWITCHES _______________________________________________

N. PTO Switch
Lift up and push switch lever forward to engage decks
and switches (O and P). Pull switch lever back to
disengage.
O. Wing Deck Switch
Used to engage or disengage both wing decks.
Depress front of switch to engage decks. Return switch
to center position to disengage decks. Pressing rear of
switch has no function. PTO switch
engaged and cutting units lowered for switch to
operate.
P. Front Deck Switch
Used to engage or disengage front deck. Depress front
of switch to engage deck. Return switch to center
position to disengage deck. Pressing rear of switch has
no function. PTO switch (N) must be engaged and
cutting units lowered for switch to operate.
Q. Light Switch
Press front of switch for road lights. Press rear of switch
for work lights. Return switch to center position to shut
off lights.
2.5

GAUGES AND CIRCUIT BREAKERS __________________________________________

V. Warning Lights
Alerts the operator to conditions requiring immediate
action. See Section 2.6.
W. Fuel Gauge
Displays fuel level in tank. Do not allow mower to run out
of fuel.
X. Voltmeter
Displays electrical system voltage.
Y. Hour Meter
Records engine operating hours. The hour meter can
be used to time maintenance intervals or mowing
operations.
Z. Circuit Breakers
Used to protect electrical system. Push down on rubber
boot to reset circuit breaker.
AA.Temperature Gauge
Displays engine coolant temperature. Do not operate
mower if temperature is above 230° F (110° C).
AB.Remote Battery Terminals
Used for connecting jumper cables with wing decks in
raised position. Keep red boot of positive remote
terminal in place when not in use.
R. 2WD / 4WD Switch
Used to switch mower between 2WD and 4WD mode.
Depress front of switch for 4WD in forward direction
only. Place switch in center position for 2WD. Depress
rear of switch for momentary 4WD in reverse. Do not
engage or disengage 4WD while mower is moving.
S. Cruise Control Switch
Depress traction pedal for desired speed and press
(N) must be front of switch to engage cruise control. Depress
service brake pedal or press rear of switch to disengage
cruise control.
T. Ignition Switch
Used to start and stop the engine. The ignition switch
has three positions OFF, RUN, and START. To prevent
unauthorized use of this mower, remove ignition key
when not in use.
U. Glow Plug Switch
Used to energize the glow plugs before starting. Do not
hold switch for more than 7 seconds. Glow Plug light will
be on when switch is depressed.
CONTROLS 2
en-9