Brakelight Bulb Replacement - Polaris SCRAMBLER 50 Service Manual

A
B
SPEED CONTROL SYSTEMS
Throttle Stop Speed Control System
Adjusting speed at the CDI is the recommended
method of speed control, but the throttle stop system
may also be used. Use the following procedure to
control how far the throttle opens.
1. Loosen the jam nut (A)
2. Turn the screw (B) inward to reduce speed or
outward to increase speed.
3. Tighten the jam nut after adjusting.
A
B
BRAKE LIGHT BULB
REPLACEMENT
If the brake light does not work the bulb may need to
be replaced.
Bulb
1. From the rear of the taillight remove two screws
holding lens cover in place and remove lens
cover.
2. Remove bulb and replace it with recommended
bulb. Apply Nyogelt grease PN 2871329.
3. Reinstall the lens cover removed in step 1.
4. Test the brakelight to see that it's working.
BATTERY
Youth ATV batteries have been upgraded to a
maintenance--free unit with more reserve capacity. A
new battery holder was designed to accommodate
the battery's larger size. For charging, it is
recommended to use
(PA- -37453) available from SPX.
YOUTH ATV BATTERY CHARGING CHART
State of Voltage Action
Charge
100% 12.8- -13 Fully
.0v Charged
75% 12.5- -12 Slight
.8v Charge
50% 12.0- -12 Charge
.5v
25% 11.5- -12 Charge
.0v
0% 11.5v or Charge
less
ELECTRICAL
Lens Cover
the Christie Charger
Charge Time*
None Required
3- -6 Hours @ 0.4A
5- -11 Hours @
0.4A
13+Hours @ 0.4A
Check State
of Charge
20 Hours @ 0.4A
Battery may
be Dead
5.3