9. Remove the washer and needle bearing.
Washer
Needle
Bearing
10. Remove the driven clutch assembly by removing
the O--ring and nut from the shaft. . Replace the
O--ring as needed.
11. Remove the three phillips screws holding the fan
in place. Remove the fan.
2.6
12. Remove the spring washer and nut from the shaft.
13. Remove the flywheel using flywheel puller.
Flywheel Puller
O--Ring
14. Scribe an alignment mark on the stator backing
plate and the crankcase for proper alignment
upon engine assembly. Remove stator assembly.
ENGINE
Flywheel Puller
( PA- -45153)