Polaris SCRAMBLER 50 Service Manual page 82

3. Install the handlebar. Secure the handlebar with
the clamps, spacers,bolts, and nuts, but do not
tighten at this point.
4. Position and tighten the left and right side controls
and brake lever clamps.
Engine Stop Switch
5. Position the handlebar on the steering post and
tighten the clamp bolts to specification.
Handlebar Mounting Clamp
Bolt Torque:
84 in.lbs. (10 Nm)
4.14
6. Check freeplay of the right side and left side front
7. Install the rear brake cable.
Start Switch
BODY/STEERING/SUSPENSION
brake cables as shown. Adjust to specifications.
Front Brake Lever Free Play:
.40-.80I (10-20 mm)
Front Brake Lever Travel:
50 cc= 1 1/8I (28 mm)
90 cc = 1 3/4² (45 mm)
specifications
Rear Brake Lever Free Play:
.40-.80I (10-20 mm)
Rear Brake Lever Travel:
50 cc= 1 1/8I (28 mm)
90 cc = 2 1/2² (65 mm)
Adjust to