Polaris SCRAMBLER 50 Service Manual page 76

4. Install the rear axle bearing carrier and rear brake
assembly on swing arm.
5. Install rear axle. Tighten the bolts until snug. The
rear axle bearing carrier needs to be adjusted for
chain tension. Do not tighten to specified torque
at this time.
6. Install the drive sprocket on the rear wheel axle.
7. Install the right and left spacer tube on the rear
wheel axle.
4.8
BODY/STEERING/SUSPENSION
Spacer Tube
8. Install the wheel hub and tighten axle nut to
specification.
Axle Nut Torque:
78-81 ft.lbs. (108-112 Nm)
9. Install rear brake cable on brake arm.
10. Install chain on drive sprocket and tighten
sprocket bolts to specification.
Sprocket Bolt Torque:
18 ft.lbs. (25 Nm)