Table of Contents
Advertisement
10. Gemini Software Installation
The Gemini Sonar is supplied with software to control the functions of the sonar and
to display the images captured by the unit. The software is supplied as an installer
package which installs the software and a number of supporting files.
10.1. System Requirements
Processor
RAM
Graphics
Display
Disk space
Networking
Operating system
10.2. Installing the Gemini Software
The Gemini software is also supplied with the sonar on a USB memory stick as a
Windows Installer Package (known as an .msi file). Doubling clicking the installation
file will start the Windows Installer and install the software onto the computer. During
installation follow the installer instructions, if required making any appropriate
selections, to install the software.
10.3. Configuring the Gemini Sonar
The Gemini head uses Ethernet to communicate between the head and the computer
running the Gemini software. Depending on the configuration of the system, this may
be partly carried over a VDSL link. Before the head can be connected to the network,
the IP address of the Gemini needs to be set to a suitable value for that network. The
subnet mask needs to be appropriate for the users network and the address chosen.
Configuring the IP address of the Gemini is a four stage process. Firstly the IP address
of the computer is set to a value which will communicate with the Gemini. The
0695-SOM-00001, Issue: 03
Minimum
2GHz
1GB
3D hardware accelerated graphics card.
1280x1024 (32bit colour)
Install is 20MB, greater than 160GB recommended for log files
100Mbit·s
-1
Windows XP 32bit
Note
Always make sure that the latest version of the Gemini software is in use.
The latest version can be downloaded from
Recommended
2GHz dual core
2GB
1600x1200 (32bit colour)
(fast Ethernet)
1000Mbit·s
Windows 7 32 or 64bit
33
Gemini Profiling System
(gigabit Ethernet)
-1
www.tritech.co.uk
© Tritech International Ltd.
Advertisement
Table of Contents
Troubleshooting
