Additional Calibration Data; Entering Tank Volume Or Bin Level; Reset Volume/Area Display Information; Reset Display Distance - Raven ENVIZIO PRO Installation And Operation Manual

Appendix A

Additional Calibration Data

Although not required operation, the following values may be programmed to enhance feedback for the
operator during field application.

Entering Tank Volume or Bin Level

The tank volume or bin level displayed on the field computer is the calculated estimate of the amount of
product remaining in the tank or bin (not the capacity of the tank or bin). The volume or level must be reset
when refilling product to allow the field computer to calculate the remaining volume during product application.
To reset the tank volume or bin level:
Touch the Tank Volume or Bin Level button to display the tank or bin configuration prompt.
1.
Touch the Tank or Bin Size button to access the Total Tank Size prompt.
2.
Use the on-screen keypad to enter the volume or level of product normally used to fill the tank or bin.
3.
Touch the Accept icon to save the entered volume. The entered value will be displayed in the Reset Tank or
4.
Reset Bin button.
When refilling the tank or bin, touch the reset button to reset the tank or bin level quickly.
5.
Low Tank Alarm
The field computer may be set to display or sound or an alarm when the calculated volume of product
remaining in the in the tank falls to a user defined level. To setup the Low Tank Alarm, refer to the Alarm
Settings section on page 116.

Reset Volume/Area Display Information

The current total area, total volume, field area and field volume information is displayed as applied information
that can be reset at any time. Refer to the Volume and Area Settings section on page 113 to reset these display
values.

Reset Display Distance

The current display distance, or odometer, registered by the field computer may be reset at any time. Refer to
the Speed section on page 101 for more information.
202 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual